Search This Blog

Thursday, April 16, 2020

3d Printer Enclosure


This whole project began because my 3d prints were failing to stick to the glass printer bed. I think its only happening in the winter because I keep the apartment on the colder side and that doesn't treat the printer well. So to help with that you can build or buy enclosures for your printer. I pretty much followed these instructions:

Using these thingiverse files to print the enclosure pieces:

I went with 3 white IKEA lack tables and printed the pieces in white as well. After everything is complete, i think it turned out nice but would have preferred the wood finished lack tables.


Below is a pic of the Led strip light controller, 2 rows of white led's and the controller are fastened to the bottom of the top table. A wemos controller is used to receive MQTT commands from the openhab/mosquitto server so lights can be turned on/off and the temperature inside can be reported back. I used a 1-wire ds18b20 temp sensor, b/c thats all I had.

I cut a hole in one of the tables, ran the wires through, and added some 3d printed brackets to hold the 3d printer controll box.

Overall turned out well, but the printer is still a POS. It will be upgraded in the future.

No comments:

Post a Comment